Garmin GPS 120XL - Manual (Page 64)

Messages &
Time Offsets
APPENDIX C
60
Active WPT Can’t be Deleted—You have attempted to change the “active to” or “active
from” waypoint. Clear the active route or GOTO before making your changes.
Accuracy has been Degraded—The accuracy of the GPS 120XL has been degraded
beyond 500 meters due to poor satellite geometry or data quality. You should check other
navigational sources to verify the position indicated.
Already Exists—The name you are entering already exists in the GPS 120XL’s memory.
Approaching—You are one minute away from reaching a destination waypoint.
Battery Power is Low—The batteries are low and should be replaced.
No DGPS Position—Not enough data is available to compute a DGPS position.
No RTCM Input— Beacon receiver is improperly connected or baud rates do not match.
Poor GPS Coverage—The GPS 120XL cannot acquire the necessary number of satellites to
compute a position. Try another location with a clearer view of the sky.
Power Down and Re-init—The GPS 120XL is not able to calculate a position due to
abnormal satellite conditions. Turn the unit off and verify the last position shown by other
means. Try the unit again later, possibly in a different location.
Read Only Mem has Failed—The permanent memory has failed and the unit is not oper-
able. Take your unit to an authorized GARMIN dealer for repairs.
Received an Invalid WPT—A waypoint was received during upload transfer that has an
invalid identifier.
Receiver has Failed—A failure in receiver hardware has been detected. If this message
persists, do not use the unit and take it to an authorized dealer for repair.
Route is Full—You have attempted to add more than 30 waypoints to a route.
Route is not Empty—You have attempted to copy into a route already in use.
Route Waypoint Can’t be Deleted—The waypoint you are trying to delete is part of a
route. Delete the waypoint from the route before removing it from memory.
Route Waypoint was Deleted—A route waypoint entered does not exist in the database
and has been deleted from the route.
RTCM Input has Failed—DGPS data being received has been lost. You are no longer
receiving the beacon signal.
Searching the Sky—The GPS 120XL is in searching the sky for almanac data or the unit is
in AutoLocate
TM mode.
The GPS 120XL uses a flashing on-screen message to
alert you to important information. Whenever the message
indicator appears, press the PAGE key to view the message
page. There are two types of messages: temporary alerts
and condition alerts. Temporary alerts are cleared from the
message page after viewing, while condition alerts remain
on the message page until the condition has been resolved.
Pay careful attention to all messages for your own safety.
120XL Man RevB 7/10/98 10:55 AM Page 60