Bosch GHP 5-14 - Manual (Page 12)

12 | English
F 016 L72 355 | (16.8.12) Bosch Power Tools
Noise/Vibration Information
Declaration of Conformity
Equipment category: 27
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS,
Stowmarket, Suffolk IP14 1EY, England
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
29.06.2012
Mounting and Operation
Starting
For Your Safety
Warning! Switch off, remove plug from mains be-
fore adjusting, cleaning or if cable is cut, dam-
aged or entangled.
Your pressure washer requires an earth connection. The op-
erating voltage is 230 V AC, 50 Hz (for non-EU countries
220 V, 240 V as applicable). Only use approved extension ca-
bles. Contact your Bosch Service Centre for details.
If you want to use an extension cable when operating your
high pressure washer, only the following cable dimensions
should be used:
– 2.5 mm
2 – max length 20 m
– 4.0 mm 2 – max length 50 m
Note: If an extension cable is used it must be earthed and con-
nected through the plug to the earth cable of your supply net-
work in accordance with prescribed safety regulations.
If in doubt contact a qualified electrician or the nearest Bosch
Service Centre.
WARNING! Inadequate extension cables can be
dangerous. Extension cable, plug and socket
must be of watertight construction and intended
for outdoor use.
Cable connections should be kept dry and off the ground.
For increased electrical safety to use a Residual Current De-
vice (RCD) with a tripping current of not more than 30 mA. Al-
ways check your RCD every time you use it.
If the supply cord is damaged, it must be replaced by a Bosch
Service Centre.
Products sold in GB only: Your product is fitted with an
BS 1363/A approved electric plug with internal fuse (ASTA
approved to BS 1362).
Measured sound values determined according to 2000/14/EC (1.60 m height, 1 m dis-
tance away).
3 600 ... J 10 1.. J10 2..
Typically the A-weighted noise levels of the product are:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
dB(A)
dB(A)
dB
84.5
92
=3
82.5
90
=3
Vibration total values (triax vector sum) determined according to EN 60335:
Vibration emission value a
h
Uncertainty K
m/s 2
m/s 2
=4.91
=1.5
=4.91
=1.5
3 600 ... J 10 1.. J10 2..
We declare under our sole responsibility that the product described under “Technical data”
is in conformity with the following standards or standardization documents: EN 60335 ac-
cording to the provisions of the directives 2011/65/EU, 2004/108/EG, 2006/42/EG,
2000/14/EG.
2000/14/EC: Guaranteed sound power level
Conformity assessment procedure according to Annex V.
dB(A) 92 90
Dr. Egbert Schneider
Senior Vice President
Engineering
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Action Figure
Delivery Scope 1
Handle Assembly 2
Filling up detergent tank 3
Water connection 4
Cleaning the Filter 5
Connecting high pressure water supply hose/
nozzle 6
Adjust water pressure 7
Adjust water jet 8
Switching on and off 9
Clean nozzle 10
OBJ_BUCH-1762-001.book Page 12 Thursday, August 16, 2012 10:03 AM