Troubleshooting – Bosch Rotak 32 LI User Manual

Page 17

Advertising
background image

English | 17

Bosch Power Tools

F 016 L70 847 | (16.4.13)

Troubleshooting

STOP

Problem

Possible Cause

Corrective Action

Machine fails to oper-
ate

Possible clogging

Remove the isolator key:
Check underneath the garden product and clear
out as necessary (always wear gardening gloves)

Battery not fully charged

Battery Charging

Battery not inserted (properly)

Inserting the battery

Grass too long

Increase height of cut and tilt garden product to re-
duce starting load

Motor protector has activated

Allow motor to cool and increase height of cut

Battery too hot/cold

Allow to cool/warm

Isolator key not inserted correctly/fully

Fit correctly

There is a short delay in the motor starting after en-
gaging the On/Off switch

Hold On/Off switch for 1 – 3 s to start motor

Motor starts and stops
immediately

Battery not fully charged

Battery Charging

Isolator key not inserted correctly/fully

Fit correctly

Battery not inserted (properly)

Inserting the battery

Battery too hot/cold

Allow to cool/warm

Increase height of cut

Machine functions
intermittently

Internal wiring of garden product damaged

Contact Service Agent

Motor protector has activated

Allow motor to cool and increase height of cut

Garden product leaves
ragged finish
and/or
Motor labours

Height of cut too low

Increase height of cut

Cutting blade blunt

Replace the blade

Possible clogging

Check underneath the garden product and clear
out as necessary (always wear gardening gloves)

Blade fitted upside down

Refit blade correctly

Area of cut (battery
duration) not large
enough

Height of cut too low

Increase height of cut and walk slower

Grass too high

Increase height of cut and walk slower

Grass wet or damp

Wait until grass is dry and walk slower

Grass is dense

Increase height of cut, walk slower and cut more
frequently

An additional battery can be purchased from an au-
thorised customer service agent for Bosch garden
products

Contact Service Agent

Cutting blade not ro-
tating while garden
product switched on

Cutting blade obstructed

Switch off garden product

Clear obstruction (always wear gardening gloves)

Blade nut/bolt loose

Tighten blade nut/bolt
(17 Nm)

Excessive vibra-
tions/noise

Blade nut/bolt loose

Tighten blade nut/bolt
(17 Nm)

Cutting blade damaged

Replace the blade

No charging procedure
possible

Battery contacts contaminated

Clean the battery contacts (e.g. by inserting and
removing the battery several times) or replace the
battery

The battery is defective, due to a disconnection in
the battery (individual cells)

Replace the battery

OBJ_BUCH-1584-004.book Page 17 Tuesday, April 16, 2013 11:34 AM

Advertising
This manual is related to the following products: