Audiopipe APCL-30001D es - Manual (Page 3)

- 1 -
English
Speaker connection
BATT+
REM
GND
Gain
Remote Bass Level Control
When using the remote bass level control you can adjust volume in the driver seat.
RCA audio input
1
2
3
4
5
6
7
8
Never connect the speaker cables with the chassis ground. This may destroy your
amplifier. Check that your speakers are connected correctly which means plus to plus
and minus to minus. We recommend speaker cable from 2.25 mm to up. The connection
ways are shown in the attachment.
Battery + terminal. The +12 Volt power cable must be connected with a fuse in linenear
the battery + terminal. Please see the table of cable and fuse selection.
Remote terminal. The remote cable must be connected with the radio remote terminal
so that the amplifier will switch on and off automatically with the radio.If there are two
or more amplifiers installed together, it might be necessary to add anadditional relay.
Please consult your dealer.
Chassis ground terminal. The chassis ground cable must be connected very tight on
a nearby massive and electric conductive place.
Gain control regulates the sensitivity of the amplifier to match the signal output voltage
of your source unit. The gain control is not a volume adjustment. Use high quality CD
music and increase the volume of your source unit to 75% posit, set the gain at the
minimum and then increase gain slowly (clockwise). Stop at the first sign of distortion,
then lower the gain a little (counter clockwise) to achieve clear undistorted music at
the maximum level.
These RCA audio inputs connect with your radio RCA outputs. Please use car audio
RCA cables, otherwise it may be disturbed. Keep these cables as short as possible.To
avoid disturbances from your car electronics, please don't close the existing car cables
when you install the RCA cables. If your radio has only one set output, please use a
suitable Y-RCA adaptor. If your radio has only speaker output, you must use a HIGH
LOW LEVEL adaptor.
Run Indicator
This LED will light up when amplifier work properly, it will flash or shut down once
amplifier in self-testing or malfunction.