Audiopipe APCL-30001D es - Manual (Page 7)

- 5 -
English
Fuse Model Wire
120 AMP
200 AMP
APCL-18001D
APCL-30001D
0 to 2 Gauge
0 to 2 Gauge
IMPORTANT:
We recommend to have the installation done by an Authorized Audiopipe Dealer.
Required power, ground wire and proper external fuse as below:
We recommend a fuse should be installed away 0.2m from the battery. The ground wire
should be connected directly with the chassis of your vehicle which should be metal to
metal ground point connection. The amplifier must be mounted securely at a solid, dry
and low vibration surface in the trunk or passenger area. Fix the amplifier in an open air
area to insure proper heat dissipation. Fix the amplifier in a place where can access easily
to set the input controllers. Install all amplifier cables as far as possible from car electrical
cables such as the car ignition cable.
• When bridging two amplifiers please refer the bridging wiring chart.
• When bridging two amplifiers you should use same model amplifiers.
• Please make sure the negative speaker terminal of two amplifiers are connected by
the same gauge cables as the positive terminal being used.
• DO NOT connect any signal cables with the input RCA jacks when bridged as slave unit.
• The LPF, Input level and remote functions will be disabled on slave amplifier when
bridged.
• All the functions of the slave amplifier will be adjusted by the master amplifier.