AASTRA 4425 IP Vision (SIP) for MX-ONE User Guide - Manual (Page 24)

25 Dialog 4425 IP Vision
Start the Phone – Log On/Off
Start the Phone – Log On/Off
Startup procedure
All the system settings for your IP phone must be set by the system
administrator before you can use the phone.
Connect the required cables.
See section “ Installation ” on page 121.
Note: Depending on the settings in your network and
telephone system, the start up procedure may be different
from phone to phone. Check the display on your phone and
read the required sections in this chapter to continue with
the start up procedure.
When the phone is connected to the network, your phone
automatically initiates the startup procedure when connected to
the mains.
Notes:
The phone does not work when a power failure occurs.
After a power failure the phone will automatically restart.
After a power failure the Call List is cleared.
When the telephone is starting up (booting) a connected PC
will loose it’s network connection for about 10 seconds.