AASTRA 4425 IP Vision (SIP) for MX-ONE User Guide - Manual (Page 51)

Contacts
Dialog 4425 IP Vision 52
Entering names and numbers
You can see the most common letters above each key on the
phone. To get the letter A press key 2 once, for B press key 2
twice, to get C press key 2 three times, and so on. It is also
possible to get other characters, see section “ Character map ” on
page 53.
Note: If the word to enter contains a digit, the digit can be
created by pressing the digit key for more than 1 second.
By default, the first character you enter is written in upper case,
and the rest of the word is written in lower case. Every new word
starts with an upper case character (that is after a space has been
entered). However, you can force the phone to enter all characters
as upper case only, or lower case only, see below. *
Press to switch between upper and lower case.
All entered characters are entered as upper or lower case. This is
only valid for the characters A-Z.
Erase Press to correct a wrong entry (see display).
If you want to try writing text, you can use the example below.
Example: To enter the name Smith
7 7 7 7
Press for S
The marked character is selected after a time out or when another
key is pressed. 6
Press for m 4 4 4
Press for i 8
Press for t 4 4
Press for h
Æ
Press to return to idle mode.
A square is shown around the available characters. If you for
example press
9
, the following character options are shown on the
display:
Press 9
A new character (w, x, y, z or 9) is selected each time you press the
key.
wxyz9