Concord TRANSFORMER XT INSTRUCTION MANUAL - Manual (Page 12)

43 42
_ GENERAL INFORMATION
• This is a “universal” child restraint system. It is approved for general use in vehicles
in accordance with ECE Regulation 44, Amendment 04 and fits most, but not all,
passenger vehicle seats.
• This child restraint system from ECE groups II and III is suitable for children from
3–12 years weighing 15–36 kg.
• It can be assumed that the system will fit correctly if the vehicle manufacturer states
in the vehicle manual that the vehicle is suitable for the installation of a “universal”
child restraint system for the relevant age group.
• This child restraint system has been classified as being of the “universal” class,
satisfying stricter conditions than previous models which do not bear this label.
• If in doubt, please consult the manufacturer of the child restraint system or the retailer.
• Only suitable for vehicles with three-point (lap and diagonal) seat belts tested and
approved in accordance with ECE Regulation 16 or a comparable standard.
_ CARE INSTRUCTIONS
The cover can be removed for washing.
To do so, move the head section ( 01 ) to its highest
position. To remove, pull the cover away from its
anchoring points. Begin by removing the head section
( 01 ) followed by the seat section and the shoulder
shields ( 02 ).
To replace, start with the cover for the seat section.
First pull the cover over the cover panel on the backrest.
Then pass it beneath the lap belt guides ( 03 ) and insert
the fixings into the channel running along the edge of the
seat. Finally, attach the cover for the head section ( 01 )
and shoulder shields ( 02 ).
• When they come into contact with moisture,
especially during washing, the cover fabrics may
fade slightly.
• Do not use solvents!