EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 139)

6.4.4. Inserting Material into a Timeline
Overview
Description
The Insert feature in Multicam consists of inserting new material into the timeline. The
timeline is loaded on the recorder and the material to insert is loaded on the player.
The Insert action can be done as a three-point edit or four-point edit.
The Insert action can be done in Insert or Overwrite mode.
This action is only possible on the Remote Panel.
Insert or Overwrite Mode
If the Insert action is performed in Insert mode, the material 'covered' is moved to the right
of the timeline. The timeline duration is increased by the duration of the inserted material.
If the Insert action is performed in Overwrite mode, the material 'covered' is overwritten
by the inserted material. The timeline duration is not modified.
Three-Point Edit
In a three-point edit, three marks must be defined on the recorder and on the player for
Multicam to be able to perform the Insert action, as shown below:
IN OUT
Recorder X X
Player X
IN OUT
Recorder X X
Player X
IN OUT
Recorder X
Player X X
IN OUT
Recorder X
Player X X
Four-Point Edit
In a four-point edit, you must insert a Mark IN and a Mark OUT both on the timeline
(recorder) and on the material loaded on the player for Multicam to be able to perform the
action.
The speed of the inserted material will automatically be adapted to the duration between
the Mark IN and Mark OUT in the timeline.
OPERATION MANUAL XSense 11.02
6. Timeline Management 131