EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 31)

2nd CTRL
Rst Cam Local Sync Prv 2nd CTRL
Cam A Cam B Cam C Cam D
This function allows the operator to swap the control of one or several play channels
between the EVS Remote and a third-party controller. Both controllers receive
permanently the status of the channel(s), but only one controller at a time is able to
actually control a channel. The secondary controllers are defined in page T2.2 of the
Technical Setup menu.
Press this function to enter the 2nd CTRL menu, select the channels that you want to
pass to the secondary controller by pressing the corresponding A or B key, then press D
(DONE) to validate your selection. Do the same to bring the control of a channel back to
the EVS remote.
See section "Secondary Controller" on page 31.
3.2.3. 1PGM+PRV Secondary Menu Controls
Introduction
The secondary menu in 1PGM+PRV mode, illustrated below, gives access to the
functions detailed in the following paragraphs:
Aud.Met. PgmSpd PostRoll
Mix. Sw to IN Search Pref
Mix / Wipe L>R / Wipe R>L / Wipe U>D / Wipe D>U / Cut
Aud.Met. PgmSpd PostRoll
Mix. Sw to IN Search Pref
These options determine the transition effect that will occur between the PGM and PRV
pictures. The mix, wipe and cut are on the same location. Pressing this button will browse
through these effects, showing the active one on the LCD menu. Please refer to Setup
menu to select the duration of the transition effect.
OPERATION MANUAL XSense 11.02
3. Control Modes 23