EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 59)

4. Press SHIFT+Page+F_ key to select the page where the clip will be stored (page 1
contains clips 110 to 199, page 2 contains clip 210 to 299, and so on).
5. Press SHIFT+F_ key to select the bank where the clip will be stored (use F1 to F9
keys as F10 is reserved for the playlist bank available on each page).
6. Press F_ key to select the location of the clip.
The clip is created in the specified location. The primary timecode of the clip is the primary
timecode defined on the train where and when the clip has been created.
Note
Press the F0 key on the Remote Panel to save ALL clips and playlists.
Example
To create a clip in location 213 (page 2, bank 1, location 3):
1. Press SHIFT+Page+F2 to select page 2.
2. Press SHIFT+F1 to select bank 1.
3. Press F3 to select location 3 on the selected page.
In the VGA Interface
To create a new clip in a player window of the VDR Panel, proceed as follows:
1. Load a record train on the player.
2. Browse the record train to reach the desired Short IN or Short OUT point.
In a Player or in a Recorder window of the VDR Panel:
3. Press ALT+I or ALT+O to mark the Short IN or Short OUT point on the current
picture.
4. The cursor is automatically placed in the adjacent field, so you can manually enter, if
you know it, the timecode of the desired Short IN or Short OUT point . Press ENTER
to confirm or ESC to cancel.
5. You can repeat this operation to define the complementary Short IN or Short OUT
point.
6. Press ALT+A-F to select and deselect the record train(s) from which the clip(s) will be
created. The letters highlighted in RED mean that a clip will be created from the
corresponding record train and the letters highlighted in GREEN mean that the
corresponding record train is available but will not be used to create a clip.
7. You can specify the name of the clip before saving it. Press ALT+N then enter the
desired name and confirm it with ENTER.
8. In a Recorder window, you can restripe the timecode of the IN point to a new value.
Press ALT+T, enter the desired value and confirm with ENTER. When creating the
clip, this timecode will replace the original one of the Short IN point.
OPERATION MANUAL XSense 11.02
4. Clip Management 51