EVS XS Version 11.01 - November 2012 Configuration Manual - Manual (Page 201)

Push Target 1 / 2
Description Specifies to which machine(s) on the network the clips must
automatically be sent when the operator uses the PUSH
function on the LSM Remote Panel.
The machines defined in this setting are also used as default
target for clip copies.
The users can define two default targets: Target 1/ Target 2.
The clips will be pushed in sequential order.
Values A list of values will be displayed depending on the value
assigned to the Target setting:
• --------:
When no target is defined in these parameters, the user
will be able to define the requested target when (s)he calls
the PUSH function.
• <network system name and number>are listed and can
be assigned for targets belonging to the SDTI network.
• <GigE server name and IP Address> are listed and can
be assigned for targets belonging on the GigE network.
Default Values -------- (No target machine specified)
Push Mode
Description Specifies how the clips should be sent using the PUSH
function, that is to say with or without the original guardbands.
Values The following values are possible:
• Short:
The clips are sent from the Short IN to the Short OUT
points, to which the guardbands of the destination machine
are added.
• Long:
The clips are sent from the Protect IN to the Protect OUT.
Default Values Short
191 3. Multicam Configuration
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B