Hafele EN 237.56.004 - Manual (Page 3)

3
Installation:
Tools needed:
• Phillips or #2 screwdriver
• Marker or pencil
• Screws:
- Wooden cabinet and door: 4 #6 wood screws (ø 3.5mm x Xmm, depending on
the thickness of the cabinet)
- If otherwise: corresponding screws, e.g. self-tapping screws with metal cabinets
• Drill Jig
• Power Supply, Article No. 917.93.004 or .005
Pre-conditions:
• Door width with inset doors:
minimum 240 mm
• Door width with overlay doors: minimum 240 mm
Recommendation:
• With cabinet doors: use self-closing hinges
• With drawers:
use self-closing drawer slides
1. EFL1 lock
2. Drilling Jig
3. Fixing Plate
4. Locking Bolt
1. Position drilling jig and EFL1 lock
If the locking bolt is inserted in the EFL1 lock:
• Connect the power supply and remove the locking bolt from the EFL1 lock by pulling it out.
2. Put the drill jig on the EFL1 lock.