High Lifter Dalton Pro Mudrunner Clutch Kit for Can-Am Outlander_Renegade 800 HO, 800 R (06-12) User Manual
Page 5
Mods and other options :
As you can see from reading the above ,CVT tuning has a lot of variables.There is no way to cover every situation. There
are other options and variations/rider preferences that may work very well. For example,some people have tires that are
on the edge of needing this kit(some 28” pure mud tires but for mixed mud /trail use),and have used the regular DBO kits
with the stock secondary spring. Some have reported great results for that from adding an alternate helix and keeping
with the stock secondary spring.If you are happy with that we are not suggesting you buy anything more than that.Others
have tried similar techniques and dislike the results. Sometimes rider preferences prefer different engagement rpms.
Some always use low range and others don't. In some cases the word “Mud” itself is speculative because it varies from
watery 2 ft deep holes to deep sticky,thick mud. Different areas,etc can make a world of difference.Engine mods can
require different shift characteristics. Some camshaft profiles require higher rpm quickly.
This is a fully adjustable kit that has guidelines that work well for most,but don't be afraid to venture into your own
experimentation.
Installation and removal of Mass Rivets
1) Push the rivet ALL the way through the hole in the flyweight. (remember to keep all rivets same direction)
2) Using a LARGE shop vise ,hold the rivet in a manner that keeps the rivet all the way through the hole so that you
will be expanding the part that protrudes from the other side.
3) Squeeze/expand the rivet using strong pressure on the vise.
For later removal of rivets if desired,use the following procedure:
1) Mark lightly the center of the flush side of the rivet with a center punch.
2) Using a 3/16” drill bit, drill approximately half way into the rivet.
3) Insert a flat ended punch with a smaller diameter straight shaft than the drilled hole(1/8” straight shaft punch) ,
and tap the rivet right through the hole.
Thank you for choosing Dalton Industries !
For other model info and tech support visit our website