Panasonic AW-RP555 - Manual (Page 29)

28 (E)
ENGLISH
Setting the travel range (limiters) of the pan/tilt head
Depending on where it has been installed, there may be obstacles within the travel range of
the pan/tilt head system with which the system may come into contact.
The pan/tilt head system may malfunction or an accident may occur if the system comes
into contact with such an obstacle.
Prior to use, be absolutely sure to set the travel range (limiters: upper, lower, left-most and
right-most limits of rotation) of the pan/tilt head system.
Before installing a pan/tilt head as a stand-alone type, set the installation direction
switch inside the pan/tilt head to stand-alone installation. (“Suspended installation” is the
factory setting.)
If this switch is not set properly, the operating directions of the pan/tilt head will be
reversed, and the limits of the pan/tilt head’s travel range (limiters) will not be stored
in the memory properly. For details on how to set the switch, refer to the operating
instructions of the pan/tilt head.
1. Select the pan/tilt head system using the CONTROL button.
2. Set the upper limit position in the travel range.
 Operate the PAN/TILT lever on the control panel to rotate the camera to the position
which is to serve as the upper limit position.
 Press the PRESET 2 and 3 buttons while holding down the MEMORY button on the
control panel.
 When the button 5 lamp lights, the setting is completed.
 To cancel the setting, press the PRESET 2 and 3 buttons again while holding down
the MEMORY button. When the setting is cancelled, the button 10 lamp lights.
3. Set the lower limit position in the travel range.
 Operate the PAN/TILT lever to rotate the camera to the position which is to serve as
the lower limit position.
 Press the PRESET 7 and 8 buttons while holding down the MEMORY button.
 When the button 5 lamp lights, the setting is completed.
 To cancel the setting, press the PRESET 7 and 8 buttons again while holding down
the MEMORY button. When the setting is cancelled, the button 10 lamp lights.
4. Set the left end position in the travel range.
 Operate the PAN/TILT lever to rotate the camera to the position which is to serve as
the left end position.
 Press the PRESET 1 and 6 buttons while holding down the MEMORY button.
 When the button 5 lamp lights, the setting is completed.
 To cancel the setting, press the PRESET 1 and 6 buttons again while holding down
the MEMORY button. When the setting is cancelled, the button 10 lamp lights.
Operation