Panasonic AW-RP555 - Manual (Page 36)

35 (E)
Operation
Preset memory settings
The multi hybrid control panel is equipped with a preset memory function for entering the
positions and settings with which the pan/tilt head system is to shoot.
Preset memory data is entered into PRESET buttons 1 through 10.
Pan/tilt head system’s settings
Pan/tilt head:
Pan/tilt position
Camera:
Zoom, focus, iris (MANU mode only), white balance
Entering preset memory data
1. Select the pan/tilt head system using the CONTROL button.
2. Use the following buttons to establish the modes.
 Press the IRIS button to establish the MANU mode (the IRIS button’s lamp now goes
off).
If the AUTO mode is established, the lens iris position will not be entered.
3. Operate the ZOOM lever and PAN/TILT lever, and on the monitor check the pictures
which are to be shot.
4. Select the white balance from among the A, B and ATW buttons, and adjust the lens iris
using the IRIS LEVEL control.
5. Set the unit to a state in which the MEMORY button is held down.
When the MEMORY button is pressed, those buttons among the PRESET buttons 1
through 10 in which data can be entered start flashing in sequence.
6. While the MEMORY button is held down, press the button in which the preset memory
data is to be entered.
7. If necessary, enter other shooting positions and settings into other buttons among
PRESET buttons 1 through 10 as preset memory data.
8. Select the next pan/tilt head system using the CONTROL button, and continue setting
the preset memory data for each system concerned.