Manhattan 177603 2D Barcode Scanner - Manual - Manual (Page 22)

22
6.3 USB paraMeter
NOTE: The Set Factory Default setting (Section 6.1.1) would return to the
original default setting instead of the customized setting. That is, if you are
using the USB interface, your device will lose USB interface settings when the
Set Factory Default code is entered. You would then need to re-scan the USB
Mode barcode.
6.4 DecoDing SeLection
6.4.1 SyMBoLogieS SeLection
PROGRAMMING CODES
<Australian Post OFF>
80 ms
100 ms
USB Mode
Australian Post ON