Manhattan 177603 2D Barcode Scanner - Manual - Manual (Page 5)

2 inStaLLation
1. If the included communication cable isn’t already attached to the scanner,
connect it to the bottom of the handle so you hear it click in place.
2. Turn off the host system.
3. Connect the scanner’s communication cable to the host system.
4. If using an optional power supply, use it now to connect the scanner to an
AC outlet.
5. Turn on the host system.
Switching the Communication Cable
Before removing a connected cable from the scanner, it’s
recommended that the host system power be turned off
and any power supply be disconnected from the scanner.
1. Insert a common pin or similar object into the pin hole
just above the cable connection (as highlighted at right).
2. Push the pin into the hole until you hear a click, then
gently remove the cable from the scanner handle.
3. Insert the replacement cable so you hear it click into
place.
3 configUration
You can set up your device by scanning all necessary programming codes for
parameters that meet your current application requirements. After these
scans, the device will save settings directly. To go back to the factory default
settings, just scan the programming code Factory Default.
3.1 changing SettingS with prograMMing coDeS
1. Turn on the scanner.
2. Change the scanner settings by scanning any of the programming codes
that meet the requirements of the current application. After reading a
valid programming code, the scanner will sound a high-pitched beep and
the green LED will light.
NOTE: At any time, you can stop your programming and scan the Factory
Default programming code to go back to the default setting(s).
3.2 factory DefaULt SettingS
Throughtout this user manual, the factory default settings are printed in bold
and are set inside brackets. See Section 7.3 for a list of readable and default
enable symbologies.
5
INSTALLATION
_
_