Soft dB Opus Suite SLM 4-Ch Module - Manual (Page 11)

8
Input Setup
Number of inputs(1 to 4)
Input type (ICP or AC)
Dynamic range
Sensor sensitivity
Display Setup
Elements to display during the measurement
Type of display (Time History, 1/3 octave Spectrum, FFT Spectrum, Numerical
Indicator , Statistics or Camera)
Record Setup
Record destination (local drive and/or Web)
DataSet ID management
Data Selection to record
Audio Setup
Photo Setup
AutoStore Setup
Generator Setup
The resulting configuration setup can be saved and recalled using File → Save Config and File → Open
Config.
5.1 Measure Controls
Run / Pause / Continue
This button starts the acquisition. The Run button then automatically becomes
the Pause button if the AutoStore is off or single mode (see section 8.3, p. 39).
This button suspends the acquisition. The Pause button then automatically
becomes the Continue button. Pause is only available if the AutoStore is off or in
single mode.
This button continues the acquisition. The Continue button then automatically
becomes the Pause button again.
Stop / Save
This button stopped the measurement. The button then automatically becomes
the Save button if the AutoStore setup is off).
This button saves the active measurement in a DataSet. This button is then
disabled until another measurement starts. This button is disabled when the
AutoStore is enabled.