Soft dB Opus Suite Data Logger Module - Manual (Page 14)

13
Step 2 Install the calibrator device on the microphone
Step 3 Click START
After the average time is elapsed, the sensitivity value will update.
Step 4 Click OK to accept the sensitivity value
6.2 Record Setup
Record Setup
Record Path
Click on the control to adjust the destination path and name of the .wav to
be recorded. This uses the Explorer Window (see section 11, p. 49).
Auto-Increment
Set the switch to
or to enable or disable the auto-increment of
the record file.
When the auto-increment is on, the name must be defined only for the first
measurement. All others measurements will be logged in a wave file with a
four-digit extension number.
For instance:
First measurement file name: test.wav
Second measurement file name: test_0001.wav
Third measurement file name: test_0002.wav
Wave File Length in the format hh:mm:ss (hour:min:sec).
In order to avoid large files that would be heavy to post-process, the data
logging will switch wave file as it reaches this length. The length is limited to
a minimum five minutes and is further limited to a Wave File Size of 1 GB.
The partition index will be had to the specified measurement name as new
partitions are created.
For instance:
Measurement name (length = 5 min): test_0002.wav
1st partition (from 0 to 5 min) : test_0002.wav
2nd partition (from 5 to 10 min): test_0002_2.wav
Nth partition (from 5∙(N-1) to 5∙N min): test_0002_N.wav