Spicer Tandem Drive Axles Pro-40 Single Reduction and Single Reduction with Differential Lock - Manual (Page 19)

16 19
Forward Assembly
17. Remove helical side gear and snap ring.
18. Remove thrust washer.
19. Remove lockout sliding clutch from the input shaft.
20. Remove the output side gear.
Note: Remove lube pump if you have one. See page 30.
21. Inspect output side gear o-rings for nicks and cuts.
Replace if necessary.
22. Install new bearing cup.
23. Remove input shaft bearing cone and oil retainer, if
necessary.
24. Press new oil retainer on input shaft.
It is not recommended to reuse the oil retainer due to possi-
ble damage that may occur while removing the input shaft
bearing cone. While pressing on new oil retainer, make
sure not to over press, and/or press with the retainer at an
angle. If the retainer is bent or distorted it may rub on the
input cage or not seal properly to the v-ring.
1—Press
2—Bearing
3—Oil retainer
4—Input shaft
1
2
3
4
CAUTION