Spicer Tandem Drive Axles Pro-40 Single Reduction and Single Reduction with Differential Lock - Manual (Page 29)

26 29
Forward Assembly
Lube Manifold Disassembly
1. Disconnect the hose from the lube manifold.
2. Remove the manifold assembly by prying it out
around the inner diameter.
IMPORTANT:
IMPORTANT: Once removed, the seal manifold assembly can-
not be reused. This component should always be replaced
with new. Use the same removal procedure for the output side
gear seal removal on the non-pump models.
Note: Seals are not sold separately from the manifold.
Lube Manifold Installation
1. Install the manifold assembly into the output side
gear bore in the carrier. Make sure the barbed nipple
is lined up with the opening in the carrier casting.
2. Install the hose clamp on the hose, push the hose
onto the barbed fitting and slide the clamp over the
barbed nipple.
3. Route the suction end of the hose through the holes
in the carrier casting to the bottom of the carrier.
4. Fully press the manifold assembly into position.
Note: Use care when pressing the manifold assembly to avoid
damaging the seals and barbed nipple. Do not over-
press plastic.
IMPORTANT
1
1 - Barbed Nipple
1
1 - Barbed Nipple