Spicer Tandem Drive Axles Pro-40 Single Reduction and Single Reduction with Differential Lock - Manual (Page 99)

96 104
Parts Identification
Fastener Torque Specifications
Forward Carrier
Note: Fasteners using self-locking thread “patches” may be reused if not damaged, but should be secured by a few drops of
Loctite #277 on threaded surface. Reused fasteners should be wiped clean of excess oil, special cleaning not required.
* Torque nut to 840 lb-ft. (1140 N•m), then continue tightening to align nut slot with nearest hole in pinion shank.
Correct torque values are extremely important to assure long Dana life and dependable performance. Under-tightening of parts
is just as harmful as over-tightening.
Exact compliance with recommended torque values will assure the best results.
The data includes class and torque tightening values.
Power Divider Class Size Tool lbs. ft. N•m
Diff. lock cover to carrier 8.8 M10 X 1.5 13 mm 28-35 38-47
Diff. lock switch 8.8 M12 X 1.5 10-12 14-16
IAD lock cover cap screw 8.8 M10 X 1.5 13 mm 28-35 38-47
Input bearing cage cap screw 10.9 M14 X 2 21 mm 114-140 155-190
Input shaft nut M42 X 1.5 55 mm 840-1020 1140-1383
Power divider cover cap screw 10.9 M14 X 2 21 mm 114-140 155-190
Diff and Gearing
Front pinion helical nut Grade 8 M42 X 1.5 65 mm 840-1020* 1140-1383*
Output shaft nut M39 X 1.5 55 mm 680-832 920-1130
Rear pinion nut 8.8 M36 X 1.5 55 mm 575-703 780-953
Ring gear nut with bolt 126219 12 M16 X 1.5 24 mm 215-255 292-346
Wheel diff. case cap screw 10.9 M14 X 2 16 mm12 pt 114-140 155-190
Carrier
Carrier to housing cap screw 12.9 M16 X 2 24 mm 230-270 312-366
Carrier to housing nut 12 M 16 X 1.5 24 mm 199-244 270-331
Differential bearing cap screw 12.9 M20 X 2.5 30 mm 350-428 475-580
Thrust bolt jam nut 4 M24 X 2 36 mm 148-181 201-245
Housing
Axle cover cap screw 12.9 M12 X 1.75 18 mm 85-103 115-140
.500-20 11/16 55-71 75-96
Axle shaft to wheel hub nuts .625-18 15/16 170-190 230-258
.750-16 1 1/8 285-345 386-468
Breather fitting - u-tube design .375-18 .750 Hex 20-26 27-35
Magnetic plug (fill) NPSF 1 X 11.5 13/16 40-60 54-81
Oil drain plug NPTF .750-14 1/2 Drive 40-60 54-81
Temperature sender/plug 40-60 54-81