Spicer Single Drive Axles Service Manual: S140 Series - Manual (Page 25)

22
Wheel Differential Assembly
Wheel Differential
Assembl
y
17. Install the half shaft so that the pin is facing upward
and push it in until it stops.
18. The end of the half shaft should fit into the slot of
the full shaft at the same time as the hole in the case
lines up with the hole in the half shaft.
19. Install the locking pins to both sides of the differen-
tial case.
20. Install outer side gear.
Note: No thrust washer is used at this location.
21. Lower the ring gear onto the case assembly aligning
the locking dowels.
22. Install and hand-tighten all new ring gear cap-
screws.
Pin Hole
Facing
Upward
Half
Differential
Shaft
Fit End
Into Slot
Align Pin
Holes
Locking
Pin