Spicer Single Drive Axles Service Manual: S140 Series - Manual (Page 33)

30
Wheel End Seal
Wheel End Seal
Remove and Overhaul Wheel End Seal
Never work under a vehicle supported by only a jack.
Always support vehicle with stands. Block the wheels and
make sure the vehicle will not roll before releasing the
brakes.
Wheel end seals can be easily damaged during handling.
Leave the seal in its package until installation to prevent
damage or contamination.
1. Remove outer nut and locking washer.
2. Remove inner nut.
3. Remove outer bearing and wheel.
4. Remove oil seal.
5. Remove inner bearing.
6. Inspect spindle journal and hub bore for scratches or
burrs. Recondition with an emery cloth as required.
Note: Deep gouges can be repaired by filling gouge with hard-
ening gasket cement and smoothing with emery cloth.
7. Clean hub cavity and bearing bores before reassem-
bly. Be sure to remove contaminants from all
recesses and corners.
8. Clean bearings thoroughly with solvent and examine
for damage. Replace damaged or worn bearings.
Always use the seal installation tool specified by the seal
manufacturer. Using an improper tool can distort or dam-
age the seal and cause premature seal failure.
Install Wheel End Seal
1. Before installation, lubricate the following with the
same lubricant used in the axle sump.
• Inner bearing.
• Wheel seal (follow the directions provided by
the seal supplier).
2. Place seal on installation tool.
3. Drive seal with installation tool onto hub.
WARNING WARNING
IMPORTANT WARNING
IMPORTANT IMPORTANT