Pinion position – Spicer Drive Axles Service Manual Wheel Reduction Drive Axles (EA-50) User Manual
Page 19
17
PINION POSITION
PINION POSITION
PINION POSITION
PINION POSITION
PINION POSITION
1
1
1
1
19.
9.
9.
9.
9. Install pinion nut and washer. Use torque multiplier
and torque pinion nut to 900-1,200 Lb-Ft (1,220-
1,627 N-m).
Pinion assembly is now ready to be installed into carrier
housing.
Ring gears and pinions are supplied in matched sets
only. Matching numbers on both the pinion and ring
gear are etched for verification. If a new gear set is
being used, verify the numbers of each pinion and ring
gear before proceeding with assembly.
When a new gear set is being installed, use a micrometer
to measure the thickness of the old pinion position shims.
Measure each shim separately and add together to get
the total thickness of the original build-up.
NO
NO
NO
NO
NOTE: If old shims ar
TE: If old shims ar
TE: If old shims ar
TE: If old shims ar
TE: If old shims are bent or m
e bent or m
e bent or m
e bent or m
e bent or mutila
utila
utila
utila
utilattttted the
ed the
ed the
ed the
ed they should
y should
y should
y should
y should
be r
be r
be r
be r
be replaced.
eplaced.
eplaced.
eplaced.
eplaced.
If a new gear set is being used, notice the (+), (–) or "0"
etching on both the old and the new pinions, and adjust
the thickness of the shims to compensate for the
difference of these two figures (as shown in table on next
page).
For example, if the old pinion is etched +2, and the new
pinion is –2, subtract .004 in. from the thickness of the
original shims used to position the pinion.
If either or both the pinion gears are etched beyond the
values on this chart, follow the same procedure to
establish correct pinion position.
For example if the old pinion is etched –12 and the new
pinion is etched +9, add .021 inch to the thickness of the
original shims.
After determining the new total build up of pinion position
shims, round the figure off to the nearest multiple of .005
inch.
Use the Pinion Setting Chart on the next page as a
guideline to set the pinion.
Pinion Assembly Complet
Pinion Assembly Complet
Pinion Assembly Complet
Pinion Assembly Complet
Pinion Assembly Completeeeee