Spicer TIMS (Tire Inflation and Monitor System) for Trailers Installation Guide - Manual (Page 11)

8
Installation
Installation
Installation
Installation Materials and Supplies
In addition to hardware provided by Dana, the installer shall
provide the following:
• Hubcaps, unless pre-installed on dressed axle.
• Pressure protection valve.
• Spindle plug driver and handle, unless plugs are
already installed in axle.
• Air lines and fittings.
• Warning lamp and wire.
• 115 psi shop air or PC/hand-held tool to set tire
pressure target.
• Optional J560 to 5-pin extension harness if trailer is
pre-ABS.
• Controller assembly mounting bolts.
Installation Introduction
Identify the bullet item below that describes the condition of
the trailer axles and proceed as directed.
• If the maintenance system hardware is already
installed on a fully dressed axle, skip to Controller
Assembly Installation.
• If tire maintenance system axle hose and spindle
plugs are already installed on the axle, skip to Rotary
Joint Assembly.
• If the axles have been pre-drilled, but no hardware
has been installed, skip to Component Installation.
• For retrofit installations start with the following pro-
cedures.