Spicer Single Drive Axles Service Manual: Single Reduction & Single Reduction with Differential Lock User Manual
Page 33
30
Wheel Differential
Ser
vice Procedure
7.
Align punch marks and install plain case half. Install
cap screws and tighten to proper specifications as
outlined in the back of this publication. Check differ-
ential for free rotation by turning side gear hub.
1 - Punch marks
8.
Install ring gear. Secure with bolts and nuts.
Note: For 17060, 19060, 21060, 22060 model axles, flange
half differential cases were redesigned starting with pro-
duction axles built in January 1997. New style ring gear
bolts are also required with the new style flange case.
Torque bolt to proper specifications. listed on page 70.
9.
Lower assembled differential assembly in to the car-
rier using a hoist and a strap. Be careful not to dam-
age the differential bearings lowering the assembly.
10. Install the bearing cup and bearing adjuster to the
flange half side first.
11. Install the bearing cup and bearing adjuster to the
plain half side. Use a long screwdriver or bar to lift
the differential up while installing the cup and bear-
ing adjuster.
1