Veris Technologies Quad 1000 Soil EC Mapping System - Operating Instructions - Manual (Page 11)

OM17-Quad1000
3-2
NOTE: Depending on shipping configuration, the unit may need additional assembly. Attach
wheels as shown in Figure 3. Attach raise-lower crank bracket as shown in Figure 4.
Figure 3 Figure 4
Attach raise/lower crank to disk electrode toolbar by threading crank rod into trunion as shown in
Figure 5. Do not attach disk electrode toolbar to frame before crank rod is attached.
Figure 5
Connect the disk-electrode sub-assembly and wiring harness as shown in Figure 6.
Figure 6a and 6b
Attach disk electrode toolbar
with 5/8” Pin and Bowtie clip.
Attach wheels with ½” X 2.75”
bolts with lock washer and
nut.
Attach raise/lower crank rod
by threading rod through
trunion
Install raise-lower crank
bracket with ½” X 3.75” bolts
with lock washer and nut.
Attach wiring harness with #6
machine screws and lock
nuts.