VTech DS6672-4 Abridged manual - Manual (Page 6)

6
Bluetooth
To use a Bluetooth enabled cell phone with your DS6671/DS6672, you must first
pair and connect your Bluetooth cell phone(s) with the telephone base. All DS6671/
DS6672 handsets can be used to make or answer calls on the cell lines.
Bluetooth wireless technology operates within a short range (a maximum of
approximately 30 feet). When you pair a Bluetooth cell phone to the telephone
base, place your Bluetooth cell phone closer to the telephone base to maintain
sufficient signal strength. For optimal performance, keep your cell phone within
 feet of the telephone base while using the cell line.
Pair and connect your first Bluetooth cell phone
Press and hold CELL 1/ CELL 2 on the telephone base for about four
seconds. You hear a tone and the CELL 1/ CELL 2 light blinks.
Turn on the Bluetooth feature of your cell phone. Once your cell phone finds
your VTech phone ( VTech DS6671/VTech DS6672), press the appropriate key
on your cell phone to continue the pairing process.
Your cell phone may prompt you to enter the PIN of the telephone base. The
default PIN of the telephone base is 0000.
.
.
•
To remove the head band from the headset:
Hold the headset with one hand and the head band with
your other hand.
Pull the end of the head band until it separates from the
rotating clip on the headset.
.
.
Headband
To attach the head band to the headset:
>%@
>$@
To wear on your left ear, hold the headset with one hand and the head band with
your other hand. Rotate the head band within the rotating clip on the headset.
•
Attach the ear pad to the headset
earpiece.
.
To wear the headset on your right ear,
insert the end [A] of the head band into
the rotating clip [B] on the headset until
it clicks into place.
3.
Remove any headset attachment
connected to the headset.
.
Adjust the head band to fit your
head. Adjust and rotate the angle of
the headset until the microphone is
pointing towards your mouth. Firmly
grip the earpiece with one hand
whenever adjusting the headset
microphone up or down.
4.
To remove the ear hook from the headset:
Hold the headset with one hand and the ear hook with your
other hand.
Pull the end of the ear hook up until it separates from the
rotating clip on the headset.
.
.