VEGA VEGAMET 602 - Manual (Page 10)

10 VEGAMET 601, 602
Mounting
Each series 600 signal conditioning instru-
ment consists of a plug-in socket for carrier
rail mounting DIN 46 277 and a module unit.
The supply voltage can be connected to
terminals 9 and 10.
For neighbouring series 600 signal condi-
tioning instruments it is possible to continue
the connection L1 and N directly via the sup-
plied plug-in jumpers.
The same is valid for the connection of VEGA-
MET voltage output 0 … 10 V to VEGASEL
voltage input 0 … 10 V, terminals 7 and 8).
Note!
It is not allowed to use the jumpers for single
instruments or at the respective end of an
instrument row. If this instruction is not ob-
served, there is the danger of contacting the
operating voltage or causing a short-circuit.
As a rule, the signal conditioning instrument
must be mounted outside the hazardous
area or special Ex protective measures must
be taken.
2 Mounting and installation instructions
Transparent cover
To protect the instrument against unauthor-
ised or inadvertent use, the front plate of
VEGAMET can be provided with a sealable
transparent cover after setup. To remove the
transparent cover see the following figure.
Mounting and installation instructions