6 setup, 1 in general, 2 adjustment elements – VEGA VEGAVIB 55 - double relay (DPDT) User Manual
Page 18
6 Setup
6.1 In general
The numbers in brackets refer to the following illustrations.
On the electronics module you will find the following indicating
and adjustment elements:
l
DIL switch for mode adjustment - min./max. (1)
l
Signal lamp (4)
Note:
As a rule, always set the mode with the mode switch (1) before
starting setup VEGAVIB 55. The switching output will change if
you set the mode switch (1) afterwards. This could possibly
trigger other connected instruments or devices.
6.2 Adjustment elements
2
3
4
1
Fig. 10: Oscillator - Relay output
1
DIL switch for mode adjustment
2
Ground terminal
3
Screwed terminals
4
Control lamp
With the mode adjustment (min./max.) you can change the
switching condition of the relay. You can set the required mode
Function/Configuration
Mode adjustment (1)
18
VEGAVIB 55 - - double relay (DPDT)
Setup
29301
-EN
-070109