VEGA VEGASON 63 Foundation Fieldbus - Manual (Page 32)

32
6 Set up with the display and adjustment module PLICSCOM
VEGASON 63 • Foundation Fieldbus
28792-EN-130417
Service
Basic adjustment 4
Display
Diagnostics
▶ Service
Info
False signal suppression 4.1
Change now?
Extended setting 4.2
Fast
level change
(> 1 m/min.)
Simulation 4.3
Start simulation?
Reset 4.4
Reset now?
Unit of measurement 4.5
m(d)
Language 4.6
German
Copy sensor data 4.7
Copy sensor data?
PIN 4.8
Enable?
Info
Basic adjustment 5
Display
Diagnostics
Service
▶
Info
Device ID 5.1
< max. 32 characters >
Sensor-TAG (PD_TAG)
< max. 32 characters >
Instrument version 5.2
VEGASON 6x
Serial number
12345678
Date of manufacture 5.3
10. April 2007
Software version
3.50
Last change using PC 5.4
10. April 2007
Sensor characteristics 5.5
Display now?
6.10 Saving the parameter adjustment data
We recommended noting the adjusted data, e.g. in this operating
instructions manual, and archiving them afterwards. They are thus
available for multiple use or service purposes.
If VEGASON 63 is equipped with a display and adjustment module,
the most important data can be read out of the sensor into the display
and adjustment module. The procedure is described in the operating
instructions manual "Display and adjustment module" in the menu
item "Copy sensor data". The data remain there permanently even if
the sensor power supply fails.
If it is necessary to exchange the sensor, the display and adjustment
module is inserted into the replacement instrument and the data are
written into the sensor under the menu item "Copy sensor data".