VEGA VEGAFLEX 63 Foundation Fieldbus - Manual (Page 28)

The following safety-relevant data are not read out or written:
l HART mode
l PIN
l Sensor length/Sensor type
l Gating out of false signals
Copy sensor data
Copy sensor data?
Basic adjustment
If the function "Reset" is carried out, the sensor resets the values of the
following menu items to the reset values (see chart):
2)
The following values will be reset:
Function Reset value
Max. adjustment Distance, upper dead zone
Min. adjustment Distance, supplied sensor length
Min. adjustment - Cable version Distance, lower dead zone
Damping ti 0 s
Linearisation linear
Sensor-TAG Sensor
Display AI-Out 1
The values of the following menu items are not reset to the reset
values (see chart) with "Reset":
Function Reset value
Language No reset
Factory setting
Like basic adjustment, in addition, special parameters are reset to
default values.
3)
Pointer
The min. and max. distance values are reset to the actual value.
Additional adjustment and diagnosis options such as e.g. scaling,
simulation or trend curve presentation are shown in the following menu
schematic. You will find a detailed description of these menu items in
the operating instructions manual "Indicating and adjustment module".
2) Sensor-specific basic adjustment.
3) Special parameters are parameters which are set customer-specifically on
the service level with the adjustment software PACTware.
Reset
Optional settings
28 VEGAFLEX 63 • Foundation Fieldbus
6 Set up with the indicating and adjustment module PLICSCOM
31844
-EN
-100426