VEGA VEGAFLEX 67 (-40…+150°C PFA insulated) 4 … 20 mA_HART four-wire - Manual (Page 27)

T his function enables reading out parameter adjustment data as well
as writing parameter adjustment data into the sensor via the indicating
and adjustment module. A description of the function is available in the
operating instructions manual "Indicating and adjustment module".
T he following data are read out or written with this function:
l M easured value presentation
l A djustment
l M edium
l V
essel form
l D amping
l L inearisation curve
l S ensor-TAG
l D isplayed value
l D isplay unit
l S caling
l C urrent output
l U nit of measurement
l L anguage
l S ensitivity
l D
ielectric figure
T he following safety-relevant data are not read out or written:
l HART mode
l PIN
l SIL
l S
ensor length/Sensor type
l F alse signal suppression
C opy sensor data
C opy sensor data?
Basic adjustment
I
f the function "Reset" is carried out, the sensor resets the values of the
following menu items to the reset values (see chart): 1)
T he following values will be reset:
Function Reset value
M ax. adjustment D istance, upper dead zone
M in. adjustment - Rod/Coax version D istance, supplied sensor length
M in. adjustment - Cable version D istance, lower dead zone
D amping ti 0 s
L inearisation L inear
S ensor-TAG S ensor
1) S ensor-specific basic adjustment.
Copy sensor data
Reset
VEGAFLEX 67 • 4 … 20 mA/HART - four-wire 27
6 S et up with the indicating and adjustment module PLICSCOM
32304
-
EN
-120329