4 mounting, 1 general instructions, 4mounting – VEGA Float for oil_water detection for for VEGACAP 63 User Manual
Page 7
4
Mounting
4
.1 General instructions
To prevent the float from touching the vessel wall, it can be guided
vertically.
Use two thin vertical rods or two vertically strained wires at a distance
of 306 mm (12 in) which you lead through the holes in the float plate.
Fig. 3: Guidance of the float
The connection cable can influence the float position of the measuring
system and therefore adulterate the measuring result.
If possible, use a light, flexible connection cable and fasten the cable
with a cable holder. In case of considerable height differences of the
float, you should use a light helix cable.
Product movements can influence the measurement. In this case, use
a signal conditioning instrument with adjustable damping to avoid
fluctuations of the measured value.
There is a danger of static charging on the plastic floating body.
Avoid friction
No dry cleaning
Do not mount in areas with flowing, non-conductive products
Guidance
Connection cable
Product movements
Static charges
Float for oil/water detection • for VEGACAP 63
7
4 Mounting
31595
-
EN
-100604