VEGA VEGALOG 571 AR - Manual (Page 8)

4 Mounting
4.1 General instructions
The module cards of VEGALOG 571 can only be mounted into
the 19" carrier BGT LOG 571. It is provided with a special bus
board for data transmission between CPU and the individual
peripheral cards (LOGBUS). The carrier is designed for
mounting into a switching cabinet or 19" housing.
The plug position for the individual cards is individually
selectable, the system saves the card positions when switch-
ing on.
Note:
The plug positions must not be changed after the parameter
adjustment because measurement loops that have already
been set up would otherwise have to be reconfigured.
4.2 Module
Setup a module for the VEGALOG 571 AR card. You will find
the description in the operating instructions manual "CPU and
carrier".
4.3 Coding
A mechanical coding system avoids later interchanging of the
various module cards in the carrier.
The coding system consists of:
l
two coded pins in the female multipoint connector
l
two holes in the male multipoint connector of the respective
component
The coded pins are attached to the module.
Equip the female multipoint connector with the two coded pins
according to the "Coding chart" and "Position of the coded
pins". The function coding points out that these are module
cards of VEGALOG. The instrument coding is used to
differentiate between the individual module cards.
The male multipoint connectors of the individual module cards
point to the holes suiting the pin positions.
Installation instructions
8 VEGALOG 571 AR - Output card relay
Mounting
31950
-EN
-060606