VEGA Connection cable IP 66_IP 68 (1 bar) - Manual (Page 3)

1 For your safety
1 .1 Appropriate use
The connection cable is used to retrofit existing plics sensors to
achieve protection IP 66/IP 68 (1bar).
1 .2 Impermissible use
As a rule, the connection cable is not allowed to be used with four-wire
instruments. Four-wire instruments are sensors whose power supply
and measurement signal are transmitted over two separate pairs of
wires.
1 .3 General safety instructions
The safety information in the operating instructions manual of the
respective sensor must be noted.
1 .4 Safety instructions for Ex areas
Please note the Ex-specific safety information for installation and
operation in Ex areas. These safety instructions are part of the
operating instructions manual and come with the Ex-approved
instruments.
For instruments with Exd or StEx approval, the use of this connection
cable is not allowed.
Connection cable IP 66/IP 68 (1 bar) • Retrofit set/Accessory for plics sensors 3
1 For your safety
34107
-
EN
-120524