VEGA VEGAMIP R61 Receiving unit - Transistor - Manual (Page 30)

Press the respective key until the indication is within the LED indication
strip. This means one or two LEDs on the LED indication strip will light
up.
C B A
2 3
1 1 1
Fig. 28: Indication board
1 Indication (LED indication board)
2 More sensitive - Key to the left
3 Less sensitive - Key to the right
A Medium: Plastics (PP, PVC …), solvents
B Medium: Building material (sand, stones …)
C Medium: Conductive substances (coal, ore, salt …)
Set the indication approximately to the middle of the LED indicating
board until the yellow status indication changes condition.
Depending on the vessel size, process and/or medium, you have to
adjust the sensitivity of VEGAMIP 61 more or less sensitive. In
products with low signal damping, in small vessels or pipelines or with
buildup, it can be necessary to test the switching function.
By means of the LED indicating board, you can see the actual
receiving level during adjustment.
When the indication moves to the right, the instrument will be more
insensitive, to the left more sensitive.
In applications with products having a good signal damping (for
example stones, ore, sand, cement) and where buildup and
contamination is expected, you should adjust the instrument more
insensitive. In this case, the VEGAMIP 61 switches only with a
relatively high signal damping by the medium. Probable buildup does
not influence the measurement.
In case of buildup, press the key (to the right) until the flashing LEDs
are at the right edge of the LED indication strip. For strong buildup, you
can press the key several times to make the instrument less sensitive.
The indication of the LED indication board does not change, but the
instrument will become a little less sensitive with each pressing of the
key.
Receiving level
Medium delivers good
signal damping
30 VEGAMIP R 61 • - Transistor
6 Setup
40694
-EN
-120228