VEGA Float for oil_water detection for VEGASWING 63 and EL 3 - Manual (Page 7)

4 Mounting
4 .1 General instructions
To prevent the float from touching the vessel wall, it can be guided
vertically.
Use two thin vertical rods or two vertically strained wires at a distance
of 306 mm (12 in) which you lead through the holes in the float plate.
Fig. 3: Guidance of the float
The connection cable can influence the float position of the measuring
system and therefore adulterate the measuring result.
If possible, use a light, flexible connection cable and fasten the cable
with a cable holder. In case of considerable height differences of the
float, you should use a light helix cable.
Product movements can influence the measurement. In this case, use
a signal conditioning instrument with adjustable damping to avoid
fluctuations of the measured value.
There is a danger of static charging on the plastic floating body.
Avoid friction
No dry cleaning
Guidance
Connection cable
Product movements
Static charges
Float for oil/water detection • for VEGASWING 63 and EL 3 7
4 Mounting
36676
-
EN
-120124