VEGA VEGAPULS 63 (≥ 2.0.0 - ≥ 4.0.0) HART and accumulator pack - Manual (Page 39)

39
6 Set up with the display and adjustment module
VEGAPULS 63 • HART and accumulator pack
40794-EN-130228
Menu Menu item Default value
Setup Measurement
loop name
Sensor
Medium Dependent on the sensor:
Liquid/Water
Bulk solids/Crushed stones, gravel
Application Demonstration
Vessel form Vessel bottom, dished boiler end
Vessel top, dished boiler end
Vesell height/
Measuring range
Recommended measuring range, see
"Technical data" in the supplement
Min. adjustment Recommended measuring range, see
"Technical data" in the supplement
Max. adjustment 0,000 m(d)
Damping 0.0 s
Current output
mode
4 … 20 mA, < 3.6 mA
Current output
Min./Max.
Min. current 3.8 mA, max. current
20.5 mA
Lock operation Released
Display Language Like order
Displayed value Distance
Display unit m
Scaling size Volume
l
Scaling 0.00 lin %, 0 l
100.00 lin %, 100 l
Backlight Switched off
Additional adjust-
ments
Distance unit m
Temperature unit °C
Probe length
Length of the standpipe Ex factory
Linearization
curve
Linear
HART mode Multidrop
Address 1
6.4 Saving the parameter adjustment data
We recommended noting the adjusted data, e.g. in this operating
instructions manual, and archiving them afterwards. They are thus
available for multiple use or service purposes.
If the instrument is equipped with a display and adjustment module,
the data in the sensor can be saved in the display and adjustment
module. The procedure is described in the operating instructions