Yamaha PSR-530 - Manual (Page 64)

62
,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,
QQQQQQQQQQQQQQQQ
QQQQQQQQQQQQQQQQ
Song Recording
◆ About the Recording with the Digital Effects Applied
You can use three Digital Effects, Reverb, Chorus and DSP, at one time. However,
two or more types from the same group cannot be selected at the same time. Be aware
the following facts especially when recording a song with the different effects applied
to the different tracks.
A
The Reverb type and Chorus type effects can be set and recorded independently
for each track. However, only the latest settings (one each) will be effective if
several effects are used in a song (the latest setting priority).
[EX.] While the panel REVERB button is turned on:
1. Select the Hall 1 (Reverb) for the Accompaniment track, and record the Accompa-
niment track for ten measures from the beginning.
2. Start recording on the Melody 1 track with the Hall 1 (Reverb) selected from the
beginning and then change the effect type to Room 1 (Reverb) respectively from
the fifth measure through the end.
When you play back the song recorded with the above condition, the first four
measures will be played back with the Hall 1 applied to both the Accompaniment
and Melody 1 tracks, and the rest six measures, from fifth through the end, with
the Room 1 applied to both tracks. The effect types set for the Accompaniment
track are replaced with the latest settings. Only the Send Levels for each track
remains the same.
B
The DSP type effects can be set and recorded only for the Melody tracks regardless
of the current effect, insertion or System. Only the latest setting will be effective
if several types are used in a song (the latest setting priority).
[EX.]
1. Turn on the panel DSP button, and start recording on the Melody 1 track with the
Distortion (DSP No.42 Hard) selected for ten measures from the beginning.
2. Turn off the panel DSP button, and start recording on the Melody 2 track without any
effect from the beginning. Then turn on the panel DSP button again at the fifth
measure, and continue recording to the end with the Rotary Speaker1 (DSP No.28
Rotary1) selected.
When you play back the song recorded with the above condition, the first four
measures will be played back with the Distortion applied only to the Melody 1
track, and the rest six measures, from fifth through the end, with the Rotary
Speaker applied only to the Melody 2 track. The DSP type set for the Melody 1
track is taken over by the one set for the Melody 2 track.