VEGA VEGABAR 67 Foundation Fieldbus - Manual (Page 22)

22
5 Connecting to power supply
VEGABAR 67 • Foundation Fieldbus
36744-EN-130321
Fig. 12: Connection steps 6 and 7
Proceed as follows:
1. Loosen the four screws on the housing base with an Allen key
size 4
2. Remove the mounting plate from the housing socket
3
2
1
Fig. 13: Components of the external housing
1 Screws
2 Wall mounting plate
3 Cable gland
3. Loop the connection cable through the cable entry on the housing
base 3)
IP 68 version with exter-
nal housing
3) The connection cable is already preconfectioned. If necessary, shorten it
to the requested length, cut the breather capillaries clean. Remove approx.
5 cm of the cable mantle, strip approx. 1 cm insulation from the ends of the
individual wires. After shortening the cable, fasten the type plate with support
back onto the cable.