VEGA VEGABAR 86 4 … 20 mA - Operating Instructions - Manual (Page 37)

37
6 Set up with the display and adjustment module
VEGABAR 86 • 4 … 20 mA
45506-EN-131010
•
The menu items "Reset, Date/Time" in the menu "Additional set-
tings"
•
Special parameters
The copied data are permanently saved in the display and adjustment
module. They remain even in case of voltage loss.
Note:
Before the data are stored in the sensor, they are checked to make
sure they match the sensor. For this purpose, the sensor type of the
source data as well as the target sensor are displayed. Storing is only
carried out after release.
In this menu item you gain access to the protected area where
you can enter special parameters. In exceptional cases, individual
parameters can be modified in order to adapt the sensor to special
requirements.
Change the settings of the special parameters only after having con-
tacted our service staff.
In menu item "Scaling" you define the scaling variable and the scaling
unit for the level value on the display, e.g. volume in l.
In menu item "Scaling (2)" you define the scaling format on the display
and the scaling of the measured level value for 0 % and 100 %.
In menu item"Current output, size" you determine which measured
value the current output refers to.
Additional adjustments -
Special parameters
Setup - Scaling (1)
Setup - Scaling (2)
Additional settings - Cur-
rent output 1 and 2 (size)