Panasonic WV-SF336 - Manual (Page 26)

26
Important:
• Be sure to use the power cord plug provided with this product.
• Be sure to fully insert the power cord plug into the 12 V DC power supply terminal (accessory).
Otherwise, it may damage the camera or cause malfunction.
• Be sure to use an AC adaptor compliant with the Specifications regarding power source and
power consumption (☞ page 39).
t Run the 12 V DC output cable through the gap of the cable hook.
12V=I
N
12 V DC output cable
Cable hook
When using PoE (IEEE802.3af compliant)
Connect a LAN cable (category 5 or better, straight, STP*) between a PoE device (such as a hub)
and the network connector of the camera.
* PAL models only
Important:
• Use all 4 pairs (8 pins) of the LAN cable.
• The maximum cable length is 100 m {328'}.
• Make sure that the PoE device in use is compliant with IEEE802.3af standard.
• When connecting both the 12 V DC power supply and the PoE device for power supply, PoE
will be used for power supply.
• When disconnecting the LAN cable once, reconnect the cable after about 2 seconds. When
the cable is quickly connected, the power may not be supplied from the PoE device.