VEGA VEGAFLEX 81 4 … 20 mA_HART two-wire Coax probe With SIL qualification - Manual (Page 70)

70
10 Diagnostics and service
VEGAFLEX 81 • 4 … 20 mA/HART two-wire
44216-EN-130823
After an electronics exchange the settings of the electronics must
be checked and verified. Only then, the instrument is again ready for
operation.
10.6 Software update
The following components are required to update the sensor soft-
ware:
•
Sensor
•
Voltage supply
•
Interface adapter VEGACONNECT
•
PC with PACTware
•
Current sensor software as file
You can find the actual sensor software as well as detailed infor-
mation of the procedure under "www.vega.com/downloads" and
"Software".
You can find information about the installation in the download file.
Make sure that you are using the correct software with SIL qualifica-
tion.
Instruments with SIL qualification can only be updated with a respec-
tive software. An accidental update with a wrong software version is
impossible.
Caution:
Instruments with approvals can be bound to certain software ver-
sions. Therefore make sure that the approval remains effective with a
software update.
You can find detailed information on www.vega.com/downloads and
"Approvals".
10.7 How to proceed in case of repair
You can find a repair form as well as detailed information on how to
proceed under www.vega.com/downloads and "Forms and certifi-
cates".
By doing this you help us carry out the repair quickly and without hav-
ing to call back for needed information.
If a repair is necessary, please proceed as follows:
•
Print and fill out one form per instrument
•
Clean the instrument and pack it damage-proof
•
Attach the completed form and, if need be, also a safety data
sheet outside on the packaging
•
Please contact for the return shipment the agency serving you. You
can find the agency on our home page www.vega.com.