VEGA VEGABAR 83 Modbus and Levelmaster protocol - Operating Instructions - Manual (Page 40)

40
6 Set up with the display and adjustment module
VEGABAR 83 • Modbus and Levelmaster protocol
46295-EN-131107
Menu item Default value
Displayed value 2 Measuring cell temperature in °C
Backlight Switched off
Reset - Diagnosis
Menu item Parameter Default value
Sensor status -
Peak value Pressure Actual measured value
Temperature Actual temperature values from meas-
uring cell, electronics
Simulation Process pressure
Reset - Additional settings
Menu item Parameter Default value
PIN 0000
Date/Time Actual date/Actual time
Copy in-
strument
settings
Special pa-
rameters
No reset
Scaling Scaling size Volume in l
Scaling format 0 % corresponds to 0 l
100 % corresponds to 0 l
Current out-
put
Current output - Size Lin. percent - Level
Current output - adjustment 0 … 100 % correspond to
4 … 20 mA
HART mode Address 0
The instrument settings are copied with this function. The following
functions are available:
•
Read from sensor: Read data from sensor and store into the
display and adjustment module
•
Write into sensor: Store data from the display and adjustment
module back to the sensor
The following data or settings for adjustment of the display and ad-
justment module are saved:
•
All data of the menu "Setup" and "Display"
•
In the menu "Additional adjustments" the items "Reset, Date/Time"
•
The user-programmable linearization curve
Additional adjustments -
Copy instrument settings