1 insert indicating and adjustment module – VEGA VEGAPULS 66 (≥ 2.0.0 - ≥ 4.0.0) enamel Modbus and Levelmaster protocol User Manual
Page 26
26
6 Set up the sensor with the indicating and adjustment module
VEGAPULS 66 enamel • Modbus and Levelmaster protocol
41368-EN-121011
6 Set up the sensor with the indicating and
adjustment module
6.1 Insert indicating and adjustment module
The indicating and adjustment module can be inserted into the sen-
sor and removed any time. Four positions displaced by 90° can be
selected. It is not necessary to interrupt the power supply.
Proceed as follows:
1. Unscrew the housing cover
2. Place the indicating and adjustment module in the requested
position onto the electronics and turn to the right until it snaps in
3. Screw housing cover with inspection window tightly back on
Removal is carried out in reverse order.
The indicating and adjustment module is powered by the sensor, an
additional connection is not necessary.
Fig. 21: Insertion of the indicating and adjustment module with single chamber
housing into the electronics compartment