VEGA VEGAFLEX series 80 Electronics module - Manual (Page 8)

8
4 Mounting
Electronics module • VEGAFLEX series 80
43656-EN-121113
1
Fig. 1: Single chamber housing
1 Position of the electronics compartment
1
Fig. 2: Double chamber housing
1 Position of the electronics compartment
Proceed as follows:
1. Switch off power supply
2. Unscrew housing cover of the electronics compartment
3. Remove the terminal blocks according to the operating instruc-
tions manual of the respective sensor
4. Loosen the two holding screws with a screwdriver (Torx size T 10
or Phillips size 4)
2
1
5 6 7 8 1 2 + ( ) (-)
Fig. 3: Loosening the holding screws
1 Electronics module
2 Screws (2 pcs.)
5. Pull the previous electronics out by using the dismounting tool.
6. Insert the new electronics module carefully.
7. Screw in the two holding screws and tighten them
8. Attach the terminal blocks according to the operating instructions
manual of the respective sensor
9. Screw the housing cover back on
The electronics exchange is now finished.