Yamaha DVD-S2500 - Manual (Page 14)

10
Preparation
SCAN MODE selector
This selector switches the type of output signal from the
COMPONENT video jacks on this unit.
INTERLACE:
Select INTERLACE if you are connecting the
component to a standard (interlace format) TV.
PROGRESSIVE:
Select PROGRESSIVE if your TV accepts NTSC
progressive or PAL progressive signals. This setting
will enable you to enjoy accurate color reproduction and
high quality images. This unit features DCDi circuit.
The PROGRESSIVE indicator on the front panel lights
up during progressive playback.
Notes:
– In the PROGRESSIVE mode, 4:3 aspect images are
stretched horizontally on the wide screen TV. We
recommend to change the TV screen’s aspect ratio
settings for progressive signals if you wish to watch
the original aspect ratio images without distortion.
You can also change the aspect ratio settings in the
[4:3 Aspect] parameter in the On-screen menu.
– Some TVs and projectors are not compatible with this
unit. If you notice picture distortion when outputting
the progressive signals, switch the SCAN MODE
selector to INTERLACE.
1 Connect the AC power cord to the power outlet.
2 Switch on the TV and this unit.
3 Set the TV to the correct Video IN channel. (e.g. EXT1,
EXT2, AV1, AV2, AUDIO/VIDEO, etc. Refer to your
TV owner’s manual for detail.)
➜ The front panel display lights up and the default
screen appears on the TV.
4 If you are using an external equipment (e.g. audio
system or receiver), turn them on and select the
appropriate input source that was used to connect to this
unit. Refer to the equipment owner’s manual for detail.
Note:
– If you do not have a proper picture or sound, refer to
“Troubleshooting” section.
We recommend to setup some of the basic menu items
before the initial playback.
1 Press STANDBY/ON to turn on the unit.
2 Press ON SCREEN.
➜ On-screen menu is displayed on the screen.
3 Follow the procedure described below to set the
following menu items.
CONSUMERS SHOULD NOTE THAT NOT ALL
HIGH DEFINITION TELEVISION SETS ARE
FULLY COMPATIBLE WITH THIS PRODUCT
AND MAY CAUSE ARTIFACTS TO BE
DISPLAYED IN THE PICTURE. IN CASE OF 525
OR 625 PROGRESSIVE SCAN PICTURE
PROBLEMS, IT IS RECOMMENDED THAT THE
USER SWITCH THE CONNECTION TO THE
“STANDARD DEFINITION” OUTPUT. IF THERE
ARE QUESTIONS REGARDING OUR VIDEO
MONITOR COMPATIBILITY WITH THIS
MODEL 525P AND 625P DVD PLAYER, PLEASE
CONTACT OUR CUSTOMER SERVICE CENTER.
This unit is compatible with the complete line of
YAMAHA products, including the projectors
DPX-1000, DPX-1100, LPX-500, LPX-510, the
plasma monitor PDM-1 and PDM-4210.
Switching on
Setups before the initial
playback
ON SCREEN